fuel gas

Wörterbuch

Beispiele im Kontext

  • fuel gas metering system

    Brenngas Dosiersystem

  • Fuel Gas

    Brenngas

  • Fuel Gas

    Fuel Gas

  • • Flame safeguard amplifier • Ignition transformer • Main fuel gas actuator • Poppet valve pneumatic cylinder rebuild kit • Poppet valve pilot solenoid valve • Process fan belt set • Spark igniter • Thermocouple kit consisting of three thermocouples • Time-off delay timer • UV flame detector • Flow transducer

    • Flame Schutzvorrichtung Verstärker • Zündung Transformator • Main Brennstoff Gas Antrieb • Sitzventil Pneumatik-Zylinder-rebuild kit • Sitzventil pilot-Magnetventil • Prozess Keilriemen Satz • Spark Zündgerät • Thermoelement-Kit bestehend aus drei Thermoelemente • Freizeit Zeitrelais • UV-Flamme-Detektor • Flow-Messwertaufnehmer

  • Development needs: Gas turbine for H2-rich fuel gas  Improvement of economics and reliability of IGCC-technology  Pilot and demo-plant testing

    Entwicklung braucht: Gas Turbine für H2 Brenngas  Verbesserung der Wirtschaftlichkeit und Zuverlässigkeit der IGCC-Technologie  Pilot-und Demo-Anlage Prüf

  • Each end cover can be lifted with eyebolts using the lifting points M16; pay attention to correct positioning so that the "primary" fuel gas flange is located downwards as per drawing.Verify that mating surfaces of flanges are not damaged and clean them if necessary.Apply the gasket (position 21) and couple the end cover to the header flange so that all special pins (position 3 on SMO9888492) are correctly inserted; then apply screws (position 30).

    Jede Endabdeckung kann mit Augenschrauben uner Nutzung der Hebestelle M16 angehoben werden; Achten Sie auf die richtige Position, damit der "primäre" entsprechend der Zeichnung nach unten gerichtet ist. Überprüfen Sie, ob die Fügeflächen der Flansche nicht beschädigt sind und reinigen Sie sie, falls erforderlich. Setzen Sie die Dichtung (Position 21) ein und verbinden die Endabdekcung zum Flanschkopf, damit alle Spezialstife (Position 3 auf SMO9888492) richtig eingesetzt sind; danach bringen Sie die Schrauben (Position 30) an.

  • fuel gas cap

    Kraftstoff-Tankdeckel

  • fuel gas drum

    Brenngas-Trommel